Print PDF
Favorite
Email
Step 7Turning the wire rod down to the right size
If you have a lathe this is a pretty straight forward job.
I made the rod 10 mm thick on both sides.
The pictures show the bottom side of the wire rod.
Make sure it fits nicely because this will determine how smooth your turbine will run.
I made the rod 10 mm thick on both sides.
The pictures show the bottom side of the wire rod.
Make sure it fits nicely because this will determine how smooth your turbine will run.
| « Previous Step | Download PDFView All Steps | Next Step » |
3
comments
|
Add Comment
|
2
Aug 10, 2009. 7:24 PMBOOJAN
says:
I must admit...i am reeeeealy jealous at your workshop....(if this is your lathe) :)
Reply
1
Aug 10, 2009. 10:39 PMrikkiesix (author)
says:
I like it too. Everyone should have a workshop like this. Its great Got a workshop and a garage connected to it so i got plenty of space. The lathe had its best time though. Its really old and not that exact anymore. Still its better then having no lathe. Greetings and thx for your comment. Erik
Reply
Feb 24, 2010. 11:20 PMDanny_Payne
says:
Im lucky, any projects i want to do from here, i can do at school, out technology department is the best!
Reply
 |
Add Comment
|
