Step 5: Putting it all together
After the paint has dried properly put it all back together and make sure to connect all disconnected wires, cables and so on.
Make a small test run to verify that all parts still do what they are supposed to do.
This concludes the greater part of the instructable, I will add some tips and tricks regarding placement of the barebone and connecting. But if you feel comfortable enough to do that on your own..stop here!
The picture I uploaded is one of my v1.0 carpc, because I can't find any of my v2.0 (which is too bad).
Main difference is that the LCD comes out of the console instead of being more part of the console
And I definitely needed to do some more sanding and painting, but I became impatient to get the thing in my car.
Make a small test run to verify that all parts still do what they are supposed to do.
This concludes the greater part of the instructable, I will add some tips and tricks regarding placement of the barebone and connecting. But if you feel comfortable enough to do that on your own..stop here!
The picture I uploaded is one of my v1.0 carpc, because I can't find any of my v2.0 (which is too bad).
Main difference is that the LCD comes out of the console instead of being more part of the console
And I definitely needed to do some more sanding and painting, but I became impatient to get the thing in my car.
Remove these ads by
Signing UpFlag this comment as:
Not NiceInappropriateSpam
Visit Our Store »
Go Pro Today »
