Building the GEK Gasifier in seven parts

Step 10 Gas cowling - 8

Weld on leg attach stubs

• 4 legs at 90 degrees separation around vessel. This is 45 degree off the front axis, like the legs of a chair.
• Overlap leg stubs 2" up side of gas cowling. 3" of stub extends below cowling.
• Use one leg as an extension jig to make sure leg is aligned while welding.
• Drill a 11/32" hole in each 1" x 10" tubing leg, about 1" down from one end
• Weld a 5/16" nut over each 11/32" hole
• Insert legs onto stubs. Use 5/16" bolts to bind them in place.