Building your own ambient color lighting bars

Step 5 Mounting

To mount the bars, I took one to home depot and found a piece of vinyl siding shaped like a U_ that it would fit into. I cut it into strips longer then the board, then cut off the extra mounting piece leaving just the U shape. I lay a strip of scotch mounting tape/foam down inside it and pressed the board in, then tucked the cable in between the plastic.

At this point I also ran some white electrical tape around the entire contraption so that the ends are not open. It's not the ideal solution but it works for now. If you are really determined, you could probably cut pieces of siding to fit into the ends as caps.

To mount the entire things on my wall I used the mounting tape again. Just two little small squares on either end were sufficient.

Comments

[bigkid2525]

Alien objekt haz cheeseburger? haha lol rotfl fuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuunny