loading

Hello! My name is Sten. As a school project for the HKU named: ARDUINO: ITTT, or: If This, Then That. We have to create an interactable program using the Arduino UNO.

In this document you will find my take on this subject and every step to create it. This is for non commercial use only. Good luck!

Step 1: Step 1: Resources Needed

1x ARDUINO

UNO

1x POWER CHORD

6x LED(2x RED, 2x ORANGE, 1x YELLOW, 1x Green)

1x BUTTON

10x CABLES

7x RESISTORS(220OHM)

BREADBOARD

Step 2: Step 2: Create the Breadboard

1. Connect

the 5V of the Arduino to the breadboard + row and a cable from the '-' to the GND

2. Connect a button to the Arduino in digital pin 2, add a resistor of 220 ohm to the '-' row and also connect it to the power supply

3. Connect a row of 6 LEDs in the order you like. But make sure you add the cables in a consecutive order, from 13 to 8, to the digital pins.

4. Each LED should have a resistor of 220 OHMS connecting to the '-' row, and a cable from the + side of the LED to the digital pin.

5. Connect the power chord to your Arduino(A LED light should blink if you put a LED in the digital pin 13)

Step 3: Step 3: the Code

Now add in the code in your Arduino editor! Attached you will find a .zip document cointaining the code! Now make

sure you verify and upload the script to your Arduino.

Step 4: Step 4: How to Play

Step 4 How

To Play

Press the reset button on your Arduino, as soon as the closest LED to the button blinks thrice you have to start tapping the button in Pin 2. When you reach 10 clicks, the first LED will light up. When you reach 20,30,40,50 and eventually 60 all the other LEDs will be lit.

Can you get all the LEDs to work? Try it alone or with your friends and enjoy the little game you have just created.

Thanks for viewing my article!

Regards,

Sten

About This Instructable

209views

4favorites

License:

More by StenDuindam:ButtonMadness 
Add instructable to: