Introduction: CAD for CD Rack

After this Design session on my computer I hated the inventor of computers, but where would we be without him? so thanks.....

Anyway this is the CAD design I made and constructed. using it was very helpful as i was able to get the most accurate measurements and results.

There were 6 different pieces, 3 had slots on the top and 3 had slots on the bottom. Altogether there are 16 pieces!!!!!! Thank fully i had a friend how helped along the way. 


Comments

About This Instructable

1,172views

6favorites

License:

Bio: Inventor
More by Alex Jalland:Vegetable PatchHow to make the Ring LampO-Lamp
Add instructable to: