Things you need / Materials and equipment list: Computer Gear Generator Program (http://woodgears.ca/gear/) Vector Drawing Program CAM generator Mach3, EMC, or similar (http://www.machsupport.com/) (http://www.linuxcnc.org/) CNC Router or a ...
(CAD – Computer Aided Design) There are so many design programs out there (http://crunkish.com/top-ten-cad-software/) (http://www.freecad.com/)http://www.freecad.com/. Some are free, some are not. Try the free ones, or the trial ...
I’ll fly through this part, as I’m sure most of you will have some experience at this.
I used an X-Acto to clean up feathers left from the cut
Using foam-sanding pads, I smoothed all the surfaces, especially the teeth
I cleaned the gears with air and a brush.
I didn’t feel that stain would improve the look.
Finished with spray polyurethane. Do this outside and wear a mask anyway.
Allow to dry completely.