Print PDF
Favorite
Email
Step 3Cutting Out the Smaller Knife Holes
The left side of the block holds smaller knives, like paring knives.
1. Sketch the pattern on the block for the position of the holes.
2. Drill a hole at each end of the small slots.
3. Use the scroll saw to cut out the piece of wood between the hole pairs. Cut from the tanget of one hole to the tangent of the other.
4. Once they are all cut out, I rounded the edges using a strip of sandpaper, pulling it back and forth through the slots like a piece of floss.
1. Sketch the pattern on the block for the position of the holes.
2. Drill a hole at each end of the small slots.
3. Use the scroll saw to cut out the piece of wood between the hole pairs. Cut from the tanget of one hole to the tangent of the other.
4. Once they are all cut out, I rounded the edges using a strip of sandpaper, pulling it back and forth through the slots like a piece of floss.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
