Print PDF
Favorite
Email
Step 4Cable clamp assembly
Once the screw eye is in the wall thread an end of the steel cable through the cable clamp first and then the screw eye.
Then thread it back through the cable clamp and tighten down the small nuts on the back of the clamp. I left about an inch or so of extra cable sticking out beyond the cable clamp just to give myself some room.
I used the needle nose pliers to tighten the tiny nuts on the back of the cable clamp.
(The pictures show this process happening on a table rather than on the wall with the screw eye mounted. This was for documentation purposes only - its best to thread the cable through the screw once its already hung.)
Then thread it back through the cable clamp and tighten down the small nuts on the back of the clamp. I left about an inch or so of extra cable sticking out beyond the cable clamp just to give myself some room.
I used the needle nose pliers to tighten the tiny nuts on the back of the cable clamp.
(The pictures show this process happening on a table rather than on the wall with the screw eye mounted. This was for documentation purposes only - its best to thread the cable through the screw once its already hung.)
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
