Introduction: Camera JIB From Camera Accessories

And don't forget to thumb up, subscribe, comment and share this video on Youtube before 15/12/2013 to win several of the pre-assembled parts so you could build your own! And for more DIY film gear check out my DIY HDSLR playlist here https://www.youtube.com/playlist?list=PLAdjMWVKvc3CifwzsKaTMS2JLNVvc-qhp

In this video I will teach you how to build a camera jib with remote tilt made from various camera accessories and you can find in a camera shop. And only need to drill 4 holes through a plastic pulley and the rest is super easy to put together.

Parts list:
2x 10cm Rope Pulley wheels KBS100K10v - http://www.wielen-bandenhuis.nl/groefwielpom.html
1x Dubble-L Bracket Falcon Eyes TMB-16T - alternatives on Ebay http://goo.gl/Hg7CLX
1x Boom arm grip adapter from Ebay - http://goo.gl/adX55Y
1x Manfrotto 234rc - http://goo.gl/WDm3Vx
1x M8 40mm Bolt
1x M8 90mm Bolt
6x M8 Nuts
4x M5 30mm Bolt
12x M5 Nuts
4x M5 bolt caps
4x Rubber bands
Few meters of washing line cable
Either a sturdy monopod or a boomarm. As if you would get a boom arm you could buy a set which included the boom arm grip plus also weights which lessen the total cost.


Follow me by liking my FB page https://www.facebook.com/bychungdha

See more on my blog http://www.chungdha.com

Comments

author
BlaineD2 (author)2016-02-05

A couple of suggestions. if you were to use a liquid rubber like DipIt tool handle liquid it would work better than the rubber bands. You appeared to not know where you were going to go next on this build even though you stated earlier this was a Mark 2 design. this made for the video to be at least twice as long as it needed to be.

author
wilgubeast (author)2013-12-06

That's a loooong video (and very professional and a cool project.) Any chance it's easy to pull screenshots and document in a way a bit more accessible for grips without broadband?

About This Instructable

3,896views

47favorites

License:

Bio: Cinematographer/Photographer /Texture Designer /Industrial Designer/Packaging Designer / Fashion Designer/Graphic Designer / Illustrator and more...
More by clam8:5 ways to use a Plastic Bag for PhotographyOverhead Camera SupportPrint on foam Microphone windshield
Add instructable to: