Introduction: Camera Stand for Overhead Photography/Recording

Picture of Camera Stand for Overhead Photography/Recording

If you liked my idea then please consider to give me a vote for the contest. To vote, please go to the upper right corner.

Most of us wants to make overhead videos or take overhead photographs. If you don't understand what overhead means, then i am telling you. Just imagine that you are writing on a paper. And you want your camera to capture only the paper, not you. Then you will need a overhead camera stand. And i am teaching here, how to make a stand for overhead recording or photography.

Step 1: What You Will Need:

Picture of What You Will Need:

** 2 pieces of single wood planks, see images for example. Height is at least 15 inch. Wight is 1.5 - 2.5 inch.

* 1 piece of flat wood, see images for example. Any height or width is acceptable. But size of a book is recommended.

* Some nails and a hammer. That's it!!.

Step 2: How to Make It?

Picture of How to Make It?

Review the images and make it carefully.

Step 3: Images Captured With Help of That Stand

Picture of Images Captured With Help of That Stand

Step 4: Result

Picture of Result

So here is the completed stand. I used the book to give the stand some support. You may also need it, when your camera is heavier than the stand can support.

Check out the video that I made using this overhead camera stand. And please give that a like.

Thank you for reading. Please share this and follow me for more tricks.

And also don't forget to subscribe to my YOUTUBE Channel here:


farkogor (author)2017-04-01

Exactly what i was looking for! Thank you very much. I was going to market to buy an overhead stand, but this instructables saved me from wasting some money.

sumondigi (author)2017-03-31

Tumi kowar agei vote dici!!

Abu Hasan Rumi (author)sumondigi2017-03-31

Thank You!!!!

sumondigi (author)2017-03-31

banglar mukh uzzwal korle bhai!!

Abu Hasan Rumi (author)sumondigi2017-03-31

এতো সামান্য প্রচেষ্টা দিয়ে বাংলার মুখ কিভাবে উজ্জ্বল করলাম? ভালো লাগলে একটা ভোট দেন। উপরে ডান কোনায় ভোটের জায়গা আছে।

sumondigi (author)Abu Hasan Rumi2017-03-31

Tumi kowar agei vote dici!!

jimmyf (author)2017-03-30

Good idea. I need to make one of these soon.

Abu Hasan Rumi (author)jimmyf2017-03-30

:) Please give me a vote from the right upper corner if you can.


Abu Hasan Rumi (author)2017-03-30

Please give a vote to me if you liked the idea. It will help me.


About This Instructable




Bio: I am mad of technologies Subscribe at:
More by Abu Hasan Rumi:Paper Ninja Star (Shuriken) - Easy Origami Ninja Star - How to Make a Paper Ninja StarSimple Camera Stand Using BottleRobotic Arm Using Cardboard
Add instructable to: