Print PDF
Favorite
Email
Step 4Drill and install screw
Drill a hole in the center (Be as precise as possible, please!) of the threaded hole where the stand normally attaches with a 13/64" bit (you can go to 6/32" if you don't have a 13/64"). On both of the clips I tried, there just happened to be a dot in the mold at the center (very handy), hopefully you will be just as lucky.
Put a washer and then a lock washer on to the 1/4-20 machine screw. Screw the screw into the clip from the threaded stand side. Push hard as the screw will be cutting it's own threads into the plastic.
Put a washer and then a lock washer on to the 1/4-20 machine screw. Screw the screw into the clip from the threaded stand side. Push hard as the screw will be cutting it's own threads into the plastic.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
