Introduction: Can Top Change Holder

Picture of Can Top Change Holder

Step 1: What You Will Need

Picture of What You Will Need

1.The top from a WILSON tennis ball can or a similar product 2.A red or black PAPER MATE marker pen or a similar product

Step 2:

Picture of

Place your fingers opposite of each other on the rim of the top and press down until it stays down on its own.

Step 3:

Picture of

Repeat step two, the top should now look like a square.

Step 4:

Picture of

Take your red or black marker and liberally trace the outline of the WILSON logo and then wipe it off with your finger but leave a thin line around the logo, this is necessary because without it you will barely be able to see the logo.

Step 5:

Picture of

Unfold the top, then use your marker to trace around the outer rim and fold the top back up into a square.

Step 6:

Picture of

Your tray look like this. Now put whatever you want in your tray. I hope you enjoy this instructable. Follow my instructables page, I will regularly be adding new projects

Step 7: One More Thing

Hey guys thanks so much for the support and viewing this project 192 times in total as of april 12, 201 and I like to say that I am making a new page and the name of that page is What The Pyro Unicorns I am not going to be using this page anymore because the username B0607727 isn't exactly the best username so if you like this project follow me on my new Instructables page I'm going going to be adding more stuff there it's going be better than this page so go check it out and again the name is What The Pyro Unicorns and thank you so much for all of your support I hope you visit the new page, bye

Comments

About This Instructable

447views

3favorites

License:

More by B0607727:Can Top Change Holder
Add instructable to: