Instructables

Candle-Powered Electric Candle

Featured

Step 4: Assemble

Picture of Assemble
4B.jpg
4C.jpg
4D.jpg
Slide the aluminum rods through each of the corner holes, such that the heat sink is resting on the shaft collars, and the cool heat sink is facing up.

Adjust the height of the shaft collars until the bottom "hot" heat sink is elevated high enough off the table to allow you to place a candle comfortably underneath with about an inch of clearance (for the flame).

Trim away the excess aluminum rod material, such that all four are flush with the top of the "cool" heat sink.
 
Remove these adsRemove these ads by Signing Up
Pro

Get More Out of Instructables

Already have an Account?

close

PDF Downloads
As a Pro member, you will gain access to download any Instructable in the PDF format. You also have the ability to customize your PDF download.

Upgrade to Pro today!