Step 13: First Connections To Board
Now that you have both the potentiometer and the relays with their connections ready you can go ahead and connect them to the board.
This is how it goes:
Pass the wires through the first hole from the underside of the board.Pass them back through the other hole and pull so that you dont have a giant loop at the top.
Those two cables will go connected to Pins 6 and 7 of the 555 timer
Now do the same for the relays, there are 3 wires to be connected to the board, two from the coils and one for the input pin. Remmember I told you to add that extra wire?
This is how it goes:
Pass the wires through the first hole from the underside of the board.Pass them back through the other hole and pull so that you dont have a giant loop at the top.
Those two cables will go connected to Pins 6 and 7 of the 555 timer
Now do the same for the relays, there are 3 wires to be connected to the board, two from the coils and one for the input pin. Remmember I told you to add that extra wire?
Remove these ads by
Signing UpFlag this comment as:
Not NiceInappropriateSpam
Visit Our Store »
Go Pro Today »
