Print PDF
Favorite
Email
Step 5Helmet top primary build
The basic shape of the top of the helmet was cut into three ribs that I glued to the top. The center flat section of cut and glued to hold the ribs in place.
The back deck was installed and then a pattern of the shape of the notches in the top flat section was made. Pieces of cardboard were cut and bent along the sharp top angle and glued to the top.
The back deck was installed and then a pattern of the shape of the notches in the top flat section was made. Pieces of cardboard were cut and bent along the sharp top angle and glued to the top.
| « Previous Step | Download PDFView All Steps | Next Step » |
1
comment
|
Add Comment
|
1
Feb 1, 2012. 4:50 PMthe dashing hero
says:
MAD CYBORG!
Reply
 |
Add Comment
|
