Print PDF
Favorite
Email
Step 3Sode
These are the cool shoulder pads.
Lames...
2" x 9" for the bottom 5 lames. The top connector lame is 3" tall. Take the top 1" though, and bend it at a 90 degree angle up. I found that if you cut the the crease on the top side, and then fold over the top 1" when you give the curve to the Sode, the top 1" will stay at 90 degrees.
I used the traditional 5 columns of lacing. Punch two holes to correlate with the should strap holes.
Lames...
2" x 9" for the bottom 5 lames. The top connector lame is 3" tall. Take the top 1" though, and bend it at a 90 degree angle up. I found that if you cut the the crease on the top side, and then fold over the top 1" when you give the curve to the Sode, the top 1" will stay at 90 degrees.
I used the traditional 5 columns of lacing. Punch two holes to correlate with the should strap holes.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
