Cardboard Seal Costume

Step 7: Torso

Have a 52inX20in rectangle or cardboard cut out. This rectangle will be broken down into 4 different parts plus 4in to make tabs on the far right side.
The first section will be 16in long, then 8in, then 16in, and finally 8in. On the far right side there will be two 4inX4in tabs that start 4in from the top and have 4in. in between them.
In both 8in sections, from the center, go up 8in from the bottom using a ruler(T3). This is where the 6inX8in circle will be located, you may use a circle template(T5) to make circle.
Finally on the last section on the left side draw two 4in slits that correspond with the tabs on the opposite side.