With Instructables you can share what you make with the world, and tap into an ever-growing community of creative experts.
The CatBot is an autonomous laser toy for your cat. You may say "But Joe, isn't the laser pointer the best toy for the lazy cat owner?" I'd ...
I was buying pet food and saw a $3 laser from PetCo. I thought the cat might like it. I was wrong. The cat became obsessed. Constantly grabbing ...
For this I used the following: Arduino Uno Hillman Hobby Parts (found @ Lowes in the screws/nuts/bolts area) 2 Servos Zip Ties $3 Laser cat toy.
The laser pops open with a screw driver. You can see it used 2x1.5v batteries. But it actually runs better at 4.5v.
The laser had to be cut up to fit on the servo arm. I drilled a hole in the center so I could mount it to the servo ...
I used a hodgepodge of these cool mechano/erector set pieces from Hillman. They can be found in the screw/small parts drawers at Lowes.
For the Arduino wiring, attach pins 8 & 9 to the servos. Attach the laser to 5v, but 470 ohm resistor inline before the laser.
Use the code in the attached file to program the Arduino.
Now that it is assembled and done watch it go...
General Public License
LazerDazer: Arduino Laser Cat Toyby robotgeek_official
Cat Laser Towerby snowbiscuit
Arduino Pan Tilt Controlled by sezgingul
Pan Tilt camera with Arduino and Joystickby Federico Vendramin
Join 2 million + to receive instant DIY inspiration in your inbox.
Download our apps!
© 2016 Autodesk, Inc.