Introduction: Cedar Limb Pendant
My sister had hired me today, so I had decided to simmer down and get to work!
As you can see I did a dog print wood burn on it.
Step 1: The Limb
I used a 1" diameter cedar limb.
I trimmed the excess bark and greens and proceeded to cut pieces around 6/16 of an inch.
Step 2: Sanding
I had used 240 grit sandpaper and sanded both sides for all of them
Step 3: Drilling & Burning
Drill a hole with a small drill bit.
Then go inside make a pattern and burn away!
Once you have it burned lightly sand it.
Now you can do what you want with these limb disc pendants!
Hope you like this instructable!
We have a be nice policy.
Please be positive and constructive.