Print PDF
Favorite
Email
Step 6Final steps
Next, Bob elected to grind the top of the brace at an angle to account for the play that is inherent to the USB charger plug. TO get the angle right, Bob plugged the phone in and held the USB plug against the brace until the phone rested in a level position. Bob used a sharpie to mark the brace at the angle that made the phne sit straight. See photo below. Bob then used a bench grinder to grind away the shaded portions of the brace. The goal for Bob was for the USB plug to fully support the phone with no other supports cluttering the charger.
Bob then mixed up some JB Weld and stuck the USB plug onto the brace, and used the yellow zip ties to hold it in the correct angle whilst it dried.
Bob then mixed up some JB Weld and stuck the USB plug onto the brace, and used the yellow zip ties to hold it in the correct angle whilst it dried.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
