Introduction: Cheap Sliding Gloves for Long Boarding

Picture of Cheap Sliding Gloves for Long Boarding

These gloves are cheap, easy, and durable. They are a lot of fun. They are also super easy to repair. And you can take them off the glove for regular use. I've seen gloves online and every where. They are like fifty bucks a piece. These are made out of stuff around the house.

Step 1: Materials

Picture of Materials

Milk jug. Old work gloves ( any glove will do) Gatorade bottle or other rigid bottle. Tape. Scissors. Knife.

Step 2: Drink Bottle

Picture of Drink Bottle

Cut out the bottom part carefully with a knife. Then cut the bottle in half. The half bottle will be cut into strips later on.

Step 3: Milk Jug

Picture of Milk Jug

Put on the glove and cut out a section of the milk jug. Cut it to fit around the thumb as seen in pictures.

Step 4: Putting It Together

Picture of Putting It Together

Follow the photos. Take a strip of the billet and put on the jug part. Tape it there. Put the round bottom on the top. Tape it. Put on the glove and tape it together. Put the bottle cap on the ring finger and tape it. Make sure it fits. If you wanted permanent just hot flu it together or super glue it.

Step 5:

Picture of

Go have fun! I am not responsible for any injuries. Know your limits.

Plz vote. Thanks!
Edit
I don't have any pictures, but I hit glued them together and they look and work better. Please comment!

Comments

About This Instructable

1,316views

2favorites

License:

More by Jaxton Maez:Arduino flashing LED lampEasy RGB LEDMini Pencil
Add instructable to: