Introduction: Cheap Workshop Stool on Castors

Picture of Cheap Workshop Stool on Castors

I was given an old vacuum cleaner for my workshop.  Very soon I understood why!  The motor failed.  I was left with a stainless steel bin on wheels.  Needing a stool for my modelling workbench removed the unwanted bits.  I then cut two discs of 10mm plywood, one the diameter of the outside of the top and one the diameter of the inside.  I stuck the two together with vinyl wood-glue and presto!  I may get round to upholstering it one day but it does a great job at the moment and provides an extra bit of storage.


Well, it's too bad the vacuum broke, but the stainless steel looks really nice!

About This Instructable




More by Graham Lane:Building a slot car track - Part One, a good foundationTool belt from plastic bottleCheap workshop stool on castors
Add instructable to: