Introduction: Christmas Rail Car 6

Picture of Christmas Rail Car 6

This is rail car number six (3d printed) in what (I hope) will be a series of ten, one published every two weeks until Christmas. This O gauge car is part of an active train.

Step 1:

Picture of

Print the base, wheels, reindeer on seat and swing holder. Files for 3d printing can be found at

Paint the reindeer.

Step 2:

Picture of

Insert the wheels into the base, then glue the swing holder onto the base (I use super glue gel).

Step 3:

Picture of

Using magnet wire or fishing line, attach the swing to the swing holder.

Step 4:

Picture of

Add the car to your rolling stock.


MsSweetSatisfaction (author)2014-10-27

This is a very cute car design. I love the idea of the reindeer swinging while on the train. Can't wait to see the full train!

About This Instructable




Bio: I am an author and a maker. My current project is Santa's Shop. I'm working on a science fiction type book--more later. @EngineerRigsby
More by MikeTheMaker:Santa's Shop 2017, the TrainSnowflake Gear WreathHappy Gear Table
Add instructable to: