Compubeaver --> How to case mod a beaver - in 29 easy steps!

Step 10 Carve out the foam

This is a very painstaking process, because you don't want to harm the structure of the animal, however, you need to use enough force to be able to carve appropriately. Plan on this taking hours, and hours and hours. I wanted the inside to be fairly consistent on all sides, and to not have bumps, etc, so this added to the time spent. While carving I did run into a couple of large wire pieces, which may have been there for structure when the foam was originally placed. I was able to cut them out with a small hack saw.

Comments

[Full Frontal Graphic]

There seems to be some sort of tallish object on the left corner of the table (in front of the chair) that I didn't spot on the materials list... will I need that?

[syphek]

that might come in handy

[fazgard]

Haha - that's for the hours of frustraion cutting!