Instructables

Computer Case Engraving

Featured

Step 7: Engraving and finishing up..

Engrave the remaining detailed areas and clear coat the whole thing.

(I went over the bigger areas with some sandpaper about 220 grit to soften up the engraving lines)
 
Remove these adsRemove these ads by Signing Up
dinsterzz7 years ago
what dremel bit did u used?
Pro

Get More Out of Instructables

Already have an Account?

close

PDF Downloads
As a Pro member, you will gain access to download any Instructable in the PDF format. You also have the ability to customize your PDF download.

Upgrade to Pro today!