Print PDF
Favorite
Email
Step 4Uprights
The unistrut faces sideways to make the bracket design simple.
Michael shapes the top end with an air wheel.
The upright hangs from the container's upper tiedown ring by a u-bolt.
The u-bolt goes through the two holes revealed by the cutout Michael is making.
We scribed, centerpunched, and then drilled the holes on a drillpress.
Stuff tends to get stacked against container walls up to about waist height, so you can saw off the bottom half of your upright and not lose much use.
We used the square channel, but the flat channel would probably work too.
Michael shapes the top end with an air wheel.
The upright hangs from the container's upper tiedown ring by a u-bolt.
The u-bolt goes through the two holes revealed by the cutout Michael is making.
We scribed, centerpunched, and then drilled the holes on a drillpress.
Stuff tends to get stacked against container walls up to about waist height, so you can saw off the bottom half of your upright and not lose much use.
We used the square channel, but the flat channel would probably work too.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
