Step 3: Connect Dioder to 16X PWM LED Fader
Strip and connect the Dioder wires up as shown. The main 12V lines connect to the big G and V1. Make sure to connect the 12V line to V1.
Then connect the 12V line to the LED strip to the small v1, which is connected to the large V1 through the board.
Finally, connect the red, blue and green lines to channels 2, 3 and 4, respectively.
If you plug in the 16X Fader board, the strip should be white since all three channels will be full on by default.
Then connect the 12V line to the LED strip to the small v1, which is connected to the large V1 through the board.
Finally, connect the red, blue and green lines to channels 2, 3 and 4, respectively.
If you plug in the 16X Fader board, the strip should be white since all three channels will be full on by default.
Remove these ads by
Signing UpFlag this comment as:
Not NiceInappropriateSpam
Visit Our Store »
Go Pro Today »
