Print PDF
Favorite
Email
Step 4Programming the Arduino
Uploading the sketch to your arduino:
1) Open the .pde file, in the source download, in the Arduino IDE
2) Connect your arduino & press Upload to I/O Board
3) Once the file is uploaded open the serial monitor
4) Go to the Arduino Controller program. If it's not running open it.
5) You can now use the On & Off buttons to control the led built in on pin 13 the arduino
1) Open the .pde file, in the source download, in the Arduino IDE
2) Connect your arduino & press Upload to I/O Board
3) Once the file is uploaded open the serial monitor
4) Go to the Arduino Controller program. If it's not running open it.
5) You can now use the On & Off buttons to control the led built in on pin 13 the arduino
| « Previous Step | Download PDFView All Steps | Next Step » |
1
comment
|
Add Comment
|
Jun 22, 2010. 6:41 PMjsklein
says:
Thanks! It worked great but I had to change the serial port number from the one you gave (A6006hmi) to my Arduino's own serial port number. It took my a while so maybe you could write in that you have to use your serial port number and not the one you give. Thanks again!
Reply
 |
Add Comment
|
