Convenient composter

Step 3 Support the Spinner

Now take that "hand truck" assembly and add a hinge and another board to it so that it will sit like an artist's easel. Drill a hole through the board that the wheels are attached to and thread a rope through it with a figure eight knot in the end of it. Once this rope is in place tie additional figure eight knots so that the angle of the spinner can be adjusted. The hinged board will need a hole large enough that these additional knots will slide freely. Attached to that hole should be a slot so that the rope will fit but not the knots. This will act like a cleat to hold the angle of this "easel" assembly.

While creating this i also noticed that this would be a good concept to implement on an actual artist's easel or on an adjustable hight saw horse.