Cool Pendants Nintendo, Super Nintendo, ATARI Pt 3

Published

Introduction: Cool Pendants Nintendo, Super Nintendo, ATARI Pt 3

About: My experience in the field of electronics led me to discover the existence of open hardware and software, in all the years that followed that discovery I just started to develop my own technologies and advis...

This is a gift for x-mas...

all the people that support my ideas if you have a 3d printer you can make it

Step 1: Design

I used 123D Design
It is an easy to use and intuitive software (My opinion) I left the editable file attached

Step 2: Export

Just Follow the image XD

Step 3: Print, Enjoy, Wear Give! Merry Xmas!

I used a Makerbot Replicator, also a I3 PRusa

Try not to give much infill

Share

    Recommendations

    • BBQ Showdown Challenge

      BBQ Showdown Challenge
    • Backpack Challenge

      Backpack Challenge
    • Stick It! Contest

      Stick It! Contest

    Discussions