Print PDF
Favorite
Email
Step 5Make a hole for the nut
The nut that's holding your bracket and frame on will stick out into your cooler, and that'll make it wobbly. So we're going to cut a shallow, <1/2" deep hole the size of the outer diameter of that nut in the side of cooler with a hole saw.
First mark where it's going to go with a sharpie. You can probably figure it out just by marking the approximate position of the bracket on the side and putting it in approximately the right place. Then drill your hole.
First mark where it's going to go with a sharpie. You can probably figure it out just by marking the approximate position of the bracket on the side and putting it in approximately the right place. Then drill your hole.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
