Step 3: Cabling
Longer cables were made up for the power and reset switch, and an additional rocker switch was added for the internal lights. In the far right drive bay sits the fan controller, the original silver Aero version had a fan built in which cooled the hard disk behind it, the new vesion is a NZXT controller, which I prefer and as the disks are now underneath the fan was redundant.
The NZXT controls fans in the disk enclosure, case and processor and gives temp readouts for all via independant sensors.
The PSU sling was made from 2 old bits of case, the bends were put in where the lines are marked, the holes correspond to the normal psu mounting holes and the 2 tags at the top slot into a couple of staps mounted on the bottom of the desk for easy removal.