Print PDF
Favorite
Email
Step 5A) Enclose the stall: Cut the lid pieces
Cut the Plexiglas if you didn't order it cut-to-size, either by scribing with an Xacto knife and breaking it, or using a table saw with a fine-tooth carbide blade.
Cut the aluminum L extrusion to length with the hacksaw. Better to err on the side of making it too long, and have to cut again, than to have it too short. But even better, measure twice and cut once. After cutting, smooth the edges with a file. Check that it fits.
Cut the aluminum L extrusion to length with the hacksaw. Better to err on the side of making it too long, and have to cut again, than to have it too short. But even better, measure twice and cut once. After cutting, smooth the edges with a file. Check that it fits.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
