Print PDF
Favorite
Email
Step 3Make it (part the second)
The two pieces that will make up the middle layers of the chucker need to be cut down to make the slot that the cracker will run in.
Again, dimensions are not critical (look at the photos to get an idea), but I left a curve of card at the far end of the chucker to give a "flick" to the cracker's flight.
Glue the layers together. I used hot-glue because it was quick, adds an element of strength to the structure, and I had already switched the thing on when I walked into the shed. Make sure that the cracker runs smoothly down the slot.
When the layers are firmly stuck, trim the ends for neatness' sake.
Again, dimensions are not critical (look at the photos to get an idea), but I left a curve of card at the far end of the chucker to give a "flick" to the cracker's flight.
Glue the layers together. I used hot-glue because it was quick, adds an element of strength to the structure, and I had already switched the thing on when I walked into the shed. Make sure that the cracker runs smoothly down the slot.
When the layers are firmly stuck, trim the ends for neatness' sake.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
