Print PDF
Favorite
Email
Step 4Route out the Foam in the Hole with the Dremel
This step takes a steady hand, and more patience. If you have worked with a Dremel before on any material, you know that as it spins at high speeds, it sometimes wants to catch on something and run across your material. If you keep your grip firm on the Dremel and hold it steady in the workspace, you should be fine.
Use a sanding bit like the one pictured below. Normally you wouldn't think of "sanding" foam, but it eats away at the foam consistently enough for good control. That's the key.
Follow the pictures.
Use a sanding bit like the one pictured below. Normally you wouldn't think of "sanding" foam, but it eats away at the foam consistently enough for good control. That's the key.
Follow the pictures.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
