Create a shower spa for a few bucks.

Step 1: Parts

You will need: 1/2 inch PVC pipe (12 to 24 inches) 1/2 inch PVC end cap 1/2 inch PVC end connection Shower hose (standard 1/2 inch connection) 1/8 in...

Step 2: Cut the PVC pipe.

A length of about 12 to 15 inches is good. Remember, the longer you go, the less powerful the spray for the same water pressure.

Step 3: Attach the end cap and connector.

You can use PVC pipe glue if the fit is not snug enough.

Step 4: Drill holes about 1 inch apart.

Do this in a straight line across the length of the pipe. Try to keep the drill perpendicular to the pipe.

Step 5: Rotate the pipe about 1/4 inch and repeat, with offset.

Drill another row of holes about one inch apart and in between the previous ones, with the pipe turned about 1/4 inch. Again, keep the drill perpendi...

Step 6: Attach the hose.

Step 7: Place the hooks in the shower at desired height, and place pipe.

Step 8: Attach to the shower head.

Here I have a "double" shower head connection where I've attached two of these. With the knob you can choose one or the other, or both. Again, the m...

Step 9: Enjoy your shower spa!

Remember to turn the holes towards the floor when you are done. Otherwise, you might get a face full of spray the next time you turn it on! This one...