The paper silhouette is simply a foreground page with an image cut out of it layered on top of a background page. The silhouettes can be placed in frames for a much more finished look and presented as gifts. You do not need mats for your frames because the silhouettes create their own mats.
Step 1: Choosing and Prepping Your Stencil
Also, every part of the design must in some way be connected to the edges of the image. In the image shown, all of the branches, flowers, etc can be followed to the edges of the images with no interruptions. The spaces where your design meets the edges of the image are your anchor points. The more anchors you have, the “sturdier” your design will be. You can certainly use an image with very few anchors, but your design will be harder to cut out.
Flip the design so you wind up with a mirror image and print it out. This printout is your stencil.
Prepping Your Stencil: Trim around the edges of the stencil leaving an even border all the way around. (If you leave a half inch boarder on one side, leave a half inch border all the way around. In my image, I left no border).
Center your stencil face up on the BACK of your foreground paper. Use a ruler to make sure it is centered because once the completed image is in a frame, a crooked design becomes more obvious. I used the ruler and a pencil to mark out the borders on the foreground paper for my stencil.
Using the scotch tape, secure all sides of the stencil. You do not need to tape the whole edge. Just make sure the edges are secure so they don’t move. It is best to have a piece of tape at each anchor point.