Print PDF
Favorite
Email
Step 3Final assembly
1. Screw in the outlet to the conduit box
2. Tighten the compression fittings around the cords (make sure to give some slack inside the box, but not too much)
3. Add the faceplate / markings that you want
In this instructable, I used two 13A cords and a 20A outlet, dues to monetary limitations and of not being able to find a higher amp outlet. This should be well above the current requirements for my compressor, but don't go trying to pull 30A out of this thing unless you have capable hardware to do it.
2. Tighten the compression fittings around the cords (make sure to give some slack inside the box, but not too much)
3. Add the faceplate / markings that you want
In this instructable, I used two 13A cords and a 20A outlet, dues to monetary limitations and of not being able to find a higher amp outlet. This should be well above the current requirements for my compressor, but don't go trying to pull 30A out of this thing unless you have capable hardware to do it.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
