Instructables
loading
loading
Picture of Credit Card SD Holder
I've been carrying around a USB flash drive on my key chain to hold all that geeky stuff I need, but I decided that was totally 2006! Now that they have those SD cards that also have the USB interface I thought I could lose some of the stuff on my key chain, and just hold one of those in my wallet. The following is an example of how that could be done, as well as pretty simple instructions(I think).
 
Remove these adsRemove these ads by Signing Up

Step 1: The supplies...

Picture of The supplies...
Knife
model SD CARD
Sharpie!
cutting board
Fake credit card

I get a few fake credit cards in things a week, so there isn't a whole lot of stress involved if/when I make a bad cut.

Step 2: Do some tracing...

Picture of Do some tracing...
Pretty simple, just trace the SD onto the paper.

Step 3: Get to cutting

Picture of Get to cutting
Also pretty simple, I used a straight edge and cut on the inside of the line I had previously drawn. That way the fit would be snug.

After a quick bit of usage testing I put some masking tape on the end of the card so that I could pull it out easily.

Good luck!
Notn47 years ago
great tut but glue another credit card under it so the SDs won't fall out