Print PDF
Favorite
Email
Step 2Build it...
The bottom line on this project is to get the 1/4" copper tubing from the tip of the hot glue gun nozzle to your air compressor. There are a variety of ways to do this. But this is how I did it.
First I bent a 6" piece of tybing to fit on the gun with the end right behind and next to the nozzle. Then I attached a valve to control the air flow. Followed by an elbow fitting and then the adpater that goes to a copper hose bib where I attatched the air compressor hose with a hose clamp. From there, another hose bib that goes to the pneumatic fitting that attaches to my air compressor.
First I bent a 6" piece of tybing to fit on the gun with the end right behind and next to the nozzle. Then I attached a valve to control the air flow. Followed by an elbow fitting and then the adpater that goes to a copper hose bib where I attatched the air compressor hose with a hose clamp. From there, another hose bib that goes to the pneumatic fitting that attaches to my air compressor.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
