Introduction: Crossbow

You will need
-3 straws
-1 long balloon
-duck tape
-3 glue sticks
-glue gun
-scissors

Step 1: Step 1

Cut slit down straw.

Step 2: Step 2

Slide 2 glue sticks into straw.

Step 3:

Cut piece of tape same length as your straw. Then rock it back and forth tell its all covered.

Step 4: Step 4

Put balloon on straw.

Step 5: Step 5

Wrap around other end. Then tape both ends.

Step 6: Step 6

Cut 2 pieces of straw about an inch long. Then glue in middle of crossbow.

Step 7: Step 7

Cut 2 more about an inch long. Then cut a slit down middle and then another one about 1/2 inch away. It should look as shown. Then glue one on each end.

Step 8: Step 8

Cut a slit down around an inch from the end. Then cut an inch and a half of glue stick and stick it in straw then wrap some tape around tell it's secure.

Step 9:

Step 10:

Step 11:

Comments

author
DIY+Hacks+and+How+Tos made it!(author)2015-11-29

Nice crossbow design

author
markusrocks made it!(author)2015-11-30

thanks

About This Instructable

674views

4favorites

License:

More by markusrocks:Crossbow
Add instructable to: