Print PDF
Favorite
Email
Step 5Epoxy LEDs to Altoid Tin
Solder wires from 4 AA battery holder to Buck puck wire.
Apply epoxy to the back of the soldered LEDs and hold in place until solid. Arctic silver thermal epoxy is probably best as the Altoid box will act as a heat sink, but I have also used standard household repair epoxy and not experienced overheating with the Cree LEDs.
Apply epoxy to the back of the soldered LEDs and hold in place until solid. Arctic silver thermal epoxy is probably best as the Altoid box will act as a heat sink, but I have also used standard household repair epoxy and not experienced overheating with the Cree LEDs.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
