This is a little vehicle I put together just for fun. Few pieces but pretty cool looking.

Step 1: The Sections

These are all the primary sections of the Mower.

Step 2: Engine and Wheels

This steps primary piece is the wind back engine that is attached to the green wheels. The engine can be subsituted for a few flat pieces and an axle. Anyway the engine stacked up with four flat pieces.

Step 3: Hood

Straight forward, two green 4x2 bricks.

Step 4: Rear and Exhaust Stacks

Now the tricky part here is the rear wheel wells that the stacks are attached to are held up by the yellow piceces on the rear. The flat one and the yellow decaled one.

Step 5: Steering Wheel and Sides

The easy way toput this section on is to put the flat yelow piece and steering wheel on the vehicle first. Than put the green pieces on the lawn underside of the thin yellow piece,

Step 6: Blade Guard or Deck

This hinged part should attach to the under-siide of the small green part added earlier.

Step 7: Grille and Front Fender

To add this assembly to what is already built I had to take the hood off and attach the grille and fender to it. Than I put the hood back on. Then you are done!! Enjoy your Custom John Deere Lawn Mower!! =)

Step 8: Coming Soon

I am working to make instructions for this Artillery truck. It's a combination of lego car and gun. It shoots two small lego bricks and can hold six bullets in it's clips. It's a little bigger than the lawn mower and the Labor Day weekend is comeing to an end, so at best it should be done next weekend.