Custom-built Computer Monitor

Step 3 Screwing in the Plexiglass and Monitor

Now you must make sure the screws will fit through the monitor and the plexiglass juuuusst enough. If you need to shorten the screws, a dremel is a quick and effective way to shorten the screws. Just make sure right after you cut a screw you put a nut a little ways onto the screw to make sure the threads are still in line.

Cut your sheet of plexiglass to cover your monitor easily. Use the excess for the base of the new monitor. This will balance out your monitor so it will not tip over. Place both pieces into the frame to mark where the screws will go, then drill in some holes with a drill. Then, when all this is complete, screw in your monitor and plexiglass to the frame.