Print PDF
Favorite
Email
Step 9Cutting Out The Windows In the Top of the Xbox 360
Before we get started first we have to remove the metal piece that is under the top of the cover. To do this just give it a good yank it and should snap right off. This piece is no use to us.
1. Decide what type of window you want and sketch it out on a piece of paper.
2. Once you are happy with what you sketched now you want to cut out the windows in the piece of paper
3. Trace the paper design on to the xbox 360 and make sure everything is straight and parallel like you want it.
4. Use a dremel with the cutting well on a low speed to cut about 1/8th of an inch away from your line.
5. Once you have cut out the window(s) take you sanding block and sand down you cuts until they are smooth and on the lines.
6. Next sand down your corners until they are also smooth and on the line.
1. Decide what type of window you want and sketch it out on a piece of paper.
2. Once you are happy with what you sketched now you want to cut out the windows in the piece of paper
3. Trace the paper design on to the xbox 360 and make sure everything is straight and parallel like you want it.
4. Use a dremel with the cutting well on a low speed to cut about 1/8th of an inch away from your line.
5. Once you have cut out the window(s) take you sanding block and sand down you cuts until they are smooth and on the lines.
6. Next sand down your corners until they are also smooth and on the line.
| « Previous Step | Download PDFView All Steps | Next Step » |
2
comments
|
Add Comment
|
Jun 14, 2010. 2:34 PMjesust1993
says:
what about the metal piece? does it not go back on?
Reply
Oct 2, 2010. 9:40 PMnathanielg
says:
It doesent
Reply
 |
Add Comment
|
