Print PDF
Favorite
Email
Step 2Overview
This is an overview of the cut off guide.
I wanted it to have a low profile so it would not interfere with the saw motor, and yet I wanted to be able to hold it firmly against the front edge of the board I am cutting, as well as be able to clamp it to the board, if need be, without the clamps getting in the way of the saw motor.
I wanted it to have a low profile so it would not interfere with the saw motor, and yet I wanted to be able to hold it firmly against the front edge of the board I am cutting, as well as be able to clamp it to the board, if need be, without the clamps getting in the way of the saw motor.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
