Print PDF
Favorite
Email
Step 5Further ammo chamber building
The ammo cover is held in place by small magnets, i built up an extra section to house these.
Pictures 1 & 2 Show the cutting and gluing of these extra sections, in order to get these to fit, i made a paper template, and trimmed it until i got a good fit.
Picture 3 - this shows the gluing and placement of magnets, make sure you take the time to align them up properly.
Picture 4 & 5 show the magnet block in place. They also show where i cut a hole clean through the gun. I then added a couple of metal sections out of a motor, and a tiny round magnet to act as the 'plutonium radioactive core' These were all glued into place using super glue, except for the magnet which is held in place by itself.
Pictures 1 & 2 Show the cutting and gluing of these extra sections, in order to get these to fit, i made a paper template, and trimmed it until i got a good fit.
Picture 3 - this shows the gluing and placement of magnets, make sure you take the time to align them up properly.
Picture 4 & 5 show the magnet block in place. They also show where i cut a hole clean through the gun. I then added a couple of metal sections out of a motor, and a tiny round magnet to act as the 'plutonium radioactive core' These were all glued into place using super glue, except for the magnet which is held in place by itself.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
