Print PDF
Favorite
Email
Step 4Colour coding
Take out your permanent colour markers! But before you start marking, first strip all remaining wire ends of their isolation for about half a cm.
Put some shrink tube on the LED's legs.
Mark the wire ends with permanent marker as shown in the picture.
Mark the connection block, on the opposite side of the transistor: red at connection running through to the C(ollector) of the transistor , blue at the E(mitter), green at the resistor and black at the connection cut through, where the B(ase)-resistor connection sits at the other side.
Put some shrink tube on the LED's legs.
Mark the wire ends with permanent marker as shown in the picture.
Mark the connection block, on the opposite side of the transistor: red at connection running through to the C(ollector) of the transistor , blue at the E(mitter), green at the resistor and black at the connection cut through, where the B(ase)-resistor connection sits at the other side.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
