Cylon Teddy Bear (Mark I)

Step 6: Glue scanner in place.

I didn't get a great picture of this step because I kept fiddling with it, but basically I cut out the original eyes and cut a horizontal slit in the head about the length of the scanner. It was a little bit more lopsided than I would have liked, but I think with a little practice I could get it just right.

I also considered removing his snout and gluing in a cylon grill, but I decided that might make him too un-cuddly. I saved some bits of fabric to use for filler material around the eyes and elsewhere as needed because my cuts weren't quite perfect.